5 Watts

Microlab TK-600 series of cable loads are ultra-wideband design forC-band & LAA applications, where extremelylow passive inter-modulation is required. A typical application isterminating MIMO small cell radios. Designer scan usethis cable load with Microlab's 2x2 and 4x4 hybrid combiners toprovide superior low PIM performance. Units are blackanodized for outdoor applications and meet 30 days ASTMB117 SaltFog Testing when used with a weather boot.

350-5925MHz 5W -161dBc 2.2-5/M IP67 Termination

A termination or load is a dissipative electronic device used atthe end of a transmission line or waveguide to convert transmittedenergy into heat, so that essentially no energy is radiated outwardor reflected back to its source.

These terminations are ideally suited for a variety ofapplicationsincluding testing, accurate measurement, and to terminate anunused port in an in-building system.

A termination or load is a dissipative electronic device used atthe end of a transmission line or waveguide to convert transmittedenergy into heat, so that essentially no energy is radiated outwardor reflected back to its source.

These terminations are ideally suited for a variety ofapplicationsincluding testing, accurate measurement, and to terminate anunused port in an in-building system.

Microlab TK-600 series of cable loads are ultra-wideband design forC-band & LAA applications, where extremely low passiveinter-modulation is required. A typical application is terminatingMIMO small cell radios. Designer scan use this cable load withMicrolab's 2x2 and 4x4 hybrid combiners to provide superior low PIMperformance. Units are black anodized for outdoor applications andmeet 30 days ASTMB117 Salt Fog Testing when used with a weather boot.

Microlab TK-600 series of cable loads are ultra-wideband design forC-band & LAA applications, where extremely low passiveinter-modulation is required. A typical application is terminatingMIMO small cell radios. Designer scan use this cable load withMicrolab's 2x2 and 4x4 hybrid combiners to provide superior low PIMperformance. Units are black anodized for outdoor applications andmeet 30 days ASTMB117 Salt Fog Testing when used with a weather boot.

Microlab TK-600 series of cable loads are ultra-wideband design forC-band & LAA applications, where extremely low passiveinter-modulation is required. A typical application is terminatingMIMO small cell radios. Designer scan use this cable load withMicrolab's 2x2 and 4x4 hybrid combiners to provide superior low PIMperformance. Units are black anodized for outdoor applications andmeet 30 days ASTMB117 Salt Fog Testing when used with a weather boot.